Binding Installation Guide

• 1. Remove the disk cover screw.
• 2. Slide the disk cover out and place to the side.
• 3. Place the disk into the center of the binding at your desired stance angles.
• 4. Align the disk with the board's inserts that you plan on using.
• 5. If mounting to a 4x2 or 4x4 pattern, use the 4 large Power Washers and 8 screws.If mounting to the Channel use the 4 standard washers and 4 screws.
• 6. Using a #3 Phillips screwdriver, hand thread each screw with a washer into place.
• 7. Start with one full turn on each screw, then contin- ue tightening one full turn each while alternating screw to screw until all screws are equally tight.
• 8. Slide the disk cover to your desired setting and rethread the screw to secure.

If you're having a hard time getting your screws to reach the inserts, begin by threading one screw with no washer. This will pull the binding closer to the top sheet and allow you to easily thread the remaining screws and washers. Once you have threaded the remaining screws, take out the first screw and reth- read with a washer.